ATTACK AS2000K 사용 설명서 - 페이지 12

{카테고리_이름} ATTACK AS2000K에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATTACK AS2000K 17 페이지. The accumulation tanks ak series; as series; hr series; hrs series; tuv series; tuvs series; s series; ss series

페이지 인쇄

4. OPErATION

Tanks accumulate heat from the heating systems for domestic or industrial use. Different types of

boilers and heating systems, renewable energy sources (heat pumps, sun collectors) or electricity

can be used to heat the water in the accumulation tank.

Heat in the tank is accumulated either by flow of the heating liquid from the heat source or by

flow of the heating liquid and the heat transfer (e.g. from solar system) through the tubular ex-

changer, or by warming by the electrical bodies installed inside the tank.

In the built-in D.H.W. tank or built-in instantaneous D.H.W. warming is the warmth accumulated

from the water in the accumulation tank.

5. INSTALLATION

The installation must be in conformity with the valid regulation and it can be done only by

a qualified specialist.

Faults caused by the incorrect installation, usage and operation cannot be considered as a war-

ranty case.

5.1 CONNECTION TO THE HEAT SOUrCE

Place the accumulation tank on the ground, as close as possible to the heat source. Install the insu-

lation. Connect the heating circuits to all inlets and outlets as it is given in the table in the chapter 3.

Mount the deaeration valve at the highest place of the system and insulate all the connection

distributions.

5.2 CONNECTION Of THE ELECTrICAL HEATING bODIES

The accumulation tank can be accessorized with the electrical heating bodies. The electrical

heating bodies can be connected to the electricity mains directly (body with an own thermostat)

or through the regulator of the whole heating system.

6. PUTTING INTO THE OPErATION

Fill the heating circuits with the appropriate liquids and deaerate the whole system. Check the

tightness of all the joints and the pressure in the system.

CAUTION: Accumulation tanks HR/HRS are filling as follow. The first, will be filled inside

tank and then remainder of accumulation tank. In case of nonobservance of process the

inside tank can be damaged.

Set the parameters of the regulation of the heating system as it is given in the documentation and rec-

ommended by the producer. Check the correct function of all control and regulation elements regularly.

Quality of the heating water significantly influences the lifetime of the heating systems. Unsuitable

quality of water may cause problems like the corrosion of device and creation of the limescale, especially