DSPPA MP 3000 소유자 매뉴얼 - 페이지 3

{카테고리_이름} DSPPA MP 3000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSPPA MP 3000 9 페이지. Very powerful public address amplifiers
DSPPA MP 3000에 대해서도 마찬가지입니다: 소유자 매뉴얼 (4 페이지)

페이지 인쇄

OPERATING PRECAUTIONS



Make sure the AC mains voltage is correct and is the same as that printed on the rear of the amplifier.



Damage caused by connecting the amplifier to improper AC voltage is not covered by the three-year US

warranty. Make sure the power switch is off before making any input or output connections.



It is always a good idea to have the gain controls turned down during power-up to prevent speaker damage if

there is a high signal level at the inputs.

INPUT CONNECTING

Input connections are made via either the 3-pin XLR-type

connectors (Figure 1) or 6.35mm sockets on the rear side

of the amplifier.

OUTPUT CONNECTING

Load can be connected using banana plugs or spade lugs. A black binding post is considered "COM", while the

three red binding posts are considered "hot".

If the PROT Led goes on steadily and the buzzer sounds while power has been turned on and signal has been fed,

there must a trouble of output shorted. please turn it off and correct the trouble then turn it on again.

ground

Figure 1 3-pin XLR-male connectors

signal

Figure2 3-pin XLR-female connectors

signal

ground