ATTEMA FTTX 사용 설명서 - 페이지 2

{카테고리_이름} ATTEMA FTTX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATTEMA FTTX 6 페이지. Distribution closure

70 cm

50 cm

Instruction manual Civil V1.0 _ XX-09-2020 _ FttX-Distribution Closure AT29030 _ Page 2 of 6

1. Strip 70cm of the DB-duct 2x Ø14/10mm.

2. Remove the base plate from the packaging.

Place the base plate on a flat surface in the

trench.

3. Seal the ports (preferably port 2 + 3) that

will NOT be used. Do this by sliding the port

seal A under the hooks and placing the

foam strips B over the hooks of the base

plate.

4. Push the DB ducts through the base plate's

hooks until they are 50 cm from the port.

Provide both ducts with an end cap.

In case that a window cut needs to be

made, then follow step 4 for both sides.

This should then look like this (see photo).

5. Push the customer cables / ducts on both

sides through the hooks of the base plate.

Max capacity per port:

2x Ø14/10mm + 48x Ø6 mm or

2x Ø14/10mm + 30x Ø8 mm

6. Take the foam port seals (A) out of the

packaging.

Keep the foam seals (B) separate for now.

They are to be used in step 11.

Fold the foam port seal A, including the

core, around the bundle of cables/ducts.