Atten AT-2190 사용자 설명서 - 페이지 8
{카테고리_이름} Atten AT-2190에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atten AT-2190 8 페이지.
페이지 인쇄Make sure that the tool is switched off and the nozzle has cooled down.
Touching a hot nozzle can lead to serious burns .Before attaching or replacing a
nozzle, allow the unit to cool down completely or use a suitable tool.
An incorrect or defective nozzle can lead to heat accumulation and damage the unit.
Use only original nozzles according to the table that are suitable for your unit.
8.INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.
Use only one hand to hold the tool, do not place your other hand over the air vents.
Prior to operation :
Mount the correct accessory for the application.
Set the desired air temperature.
8.1 Switching on and off
To switch the tool on, set the on/off switch to position Ⅰ/Ⅱ. Some smoke may be emitted
after switching on; this does not indicate a problem.
To switch the tool off, set the on/off switch to position Ⅰ , and let it run for a few minutes.
Then set the on/off switch to position 0. Let the tool cool down before moving or storing it.
8.2 Temperature setting
Turn ON/OFF switch to Ⅰ/Ⅱ, depending on temperature you need. The heat gun will start to buzz.
8.3 Stripping paint
Mount an appropriate accessory.
Set a high air temperature.
Switch the tool on.
Direct the hot air onto the paint to be removed.
When the paint softens, scrape the paint away using a hand scraper.
Do not strip metal window frames, as the heat may be conducted onto the glass
and crack it. When stripping other window frames, use the glass protection nozzle.
Do not keep the tool directed at one spot too long to prevent igniting the surface.
Avoid collecting paint on the scraper accessory, as it may ignite. If necessary,
carefully remove paint debris from the scraper accessory using a knife.
8.4 Stationary use
This tool can also be used in stationary mode.
Secure the cable to prevent pulling the tool off the workbench.
Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.
8.5 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting
to move or store the tool.
To reduce the cooling time, set the on/off switch to position Ⅰ and let it run for a few minutes.
Switch the tool off and let it cool down for at least 30 minutes.
9.MAINTENANCE AND CLEANING
Attention! Before performing any work on the equipment, pull the power plug.
9.1 Maintenance
Your Power Tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
9.2 Lubrication
Your power tool requires no additional lubrication.
9.3 Cleaning
Keep the ventilation slots clear and regularly clean the housing with a soft cloth.
9.4 Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents
may damage the plastic parts.