DSR INC-406AC 소유자 매뉴얼 - 페이지 8

{카테고리_이름} DSR INC-406AC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSR INC-406AC 12 페이지. Automatic battery charger

NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not

allowed in Canada. Use of an adapter plug in the United States is not

recommended.

8.2

Recommended minimum AWG size for extension cord:

•

100 feet long or less - use an 14 gauge extension cord.

•

Over 100 feet long - use a 12 gauge extension cord.

ASSEMBLY INSTRUCTIONS

No assembly required

10.

To mount the charger to a wall or other flat surface:

10.1

Remove the two screws from one side of the unit near the back.

10.2

Attach a mounting bracket, with the keyhole towards the top, using the screws

you just removed.

10.3

Repeat for the other side. Note: Completely install one bracket before moving

to the next.

10.4

Using the charger as a template, install two #10 panhead screw anchors (or

equivalent) into the wall you want to mount the charger to. Leave the heads

of the screws extended 1/16" away from the surface. The mounting brackets

are designed to match the 16" wall stud spacing commonly found in wood and

steel framed buildings, for increased support install the anchors into the wall

studs. NOTE: Make sure the screw/anchor combination installed into the wall

is able to support up to fifty pounds of weight.

10.5

Position the charger, with the mounting brackets installed, so that the keyhole

slots on the mounting brackets line up with both screws you installed. Then

slide the charger down so that the screw heads lock in the keyhole slot of the

mounting brackets.

•