DSR INC100 소유자 매뉴얼 - 페이지 6

{카테고리_이름} DSR INC100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSR INC100 16 페이지. Battery charger/power supply

9. CONTROL PANEL

LED Indicators

CONNECTED (yellow/orange) LED

The CONNECTED LED will light when the battery is properly connected.

CHARGING (yellow/orange) LED

When charging begins, the CHARGING LED will light.

CHARGED (green) LED

The CHARGED LED will light when the charger has gone into maintain mode.

and

(UP and DOWN) Buttons

Use these buttons to select the amount of time or voltage, depending on the display

function selected.

(Start/Stop) Button

This is the start and stop button for all modes.

Digital Display

The Digital Display gives a digital indication of voltage, amperes or time, depending on the

display function chosen.

Display Button

Use this button to set the function of the digital display to one of the following:

• VOLTS (Voltmeter)

The voltmeter indicates the voltage at the battery terminals. If the reading is 12.8 volts or

more, the battery is charged.

• AMPS (Ammeter)

The ammeter indicates the amount of current, measured in amps, that is being drawn by

the battery (± 2 amps).

NOTE: The 70 amp charge rate cycles between 20 amps and 70 amps during the charging

process and the ammeter will show this. This is a normal condition.

• TIME (Timer – Range: 10 minutes to 120 minutes)

Used only in manual mode, the main function of the timer is to prevent overcharging

while allowing a battery time to obtain a satisfactory charge. To properly set the timer,

you must know the size of the battery in ampere hours or reserve capacity in minutes

and the state of charge.

▫ Hold: This position defeats the timer function, allowing for continuous operation. Use

when you want to charge more than 2 hours. Be sure to monitor the charging procedure

and stop when the battery is charged. Not doing so may cause damage to your battery

or may cause other personal property damage or personal injury.

• 6 •