Attero Tech Dante unDX2IO+ 사용자 설명서 - 페이지 8
{카테고리_이름} Attero Tech Dante unDX2IO+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attero Tech Dante unDX2IO+ 16 페이지. 4 x 2 wallplate
페이지 인쇄2.1 – Mounting
A typical installation will involve mounting the wall plate into a pre mounted wall box or mounting bracket. Before starting,
make sure the wall box where the unDX2IO+ is to be installed is pre-wired with a suitable cable back to a PoE-enabled
network switch or mid-span injector. If a mid-span injector is being used, the cable should be connected to the port that
supplies both Ethernet and power (refer to the devices manual if unsure which port is which).
*Note: All Attero Tech products are tested using UTP cabling and it is recommended that UTP cabling be used when
installing them. STP cabling can be used for installation though care must be taken not introduce grounding issues into
the system by doing so.
Attach the network cable from the switch/mid-span injector to the Dante port of the Dante unDX2IO+. If the switch or
mid-span injector is already running and PoE is enabled, the unit should power up and the green ID LED on the front of
the device should turn on.
With the cable attached, carefully place the unDX2IO+ into the wall box taking care to not trap the cabling. Once full in
place, secure it with the screws provided. Once the unit is secured in the wall box, fit the Decora plate and secure it with
the screws provided with it.
The figure below shows the installation of the companion passive XLR audio input plate and the unDX2IO+.
Figure 2 - unDX2IO+ Installed with unAX2I (Rear View)
Attero Tech, LLC
1315 Directors Row, Suite 107, Ft Wayne, IN 46808
Phone 260-496-9668 • Fax 260-496-9879
www.atterotech.com
614-00036
unDX2IO+
User Manual