aTTo Digital TileRec 사용자 설명서 - 페이지 4

{카테고리_이름} aTTo Digital TileRec에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. aTTo Digital TileRec 8 페이지. Voice activated recorder

When VOS is turned on, the LED lights will flash, and when in continuous recording mode, the LED lights

will remain on. The above is when the LED light is set to on.

C. Setting LED

In the third line of the RECSET file:

Write 1 if you want the LED to flash during recording.

Write 0 if you prefer no LED flash during recording.

Keep in mind that when you turn the device ON the LED will flash 10 times to signal the microphone

initiating, regardless of the setting. After the 10 flashes, the LED will act according to your input.

D. Timed Sectioning for Audio Files

In the fourth line of the RECSET file the value of your preferred length for an audio file.

For example, if you'd like to have 30-minute files, you will need to input 30 in the 4th line of

the text file.

Sectioning audio will allow easier shuffling through information while on the go.

Connect TileRec to a PC

A. Connect to a computer with USB port

1. Make sure your TileRec device is turned off. Slide the REC button to the "OFF" position

to ensure the device is off and to make sure that any ongoing recordings are properly

saved.

2. Make sure your PC is turned on and awake. Unlock the system if it's locked.

3. Insert the USB termination of the cable that came with your TileRec device into the USB

port on your PC.

4. Connect the USB-C end of the cable to the USB-C port on your TileRec Mini Voice

Recorder.

5. To access the recordings, open "My PC" ( for Windows) or "Devices" (for macOS).

6. You should see the TileRec device appear as a new drive. Double-click on it to access

its contents. In the folder RECORD you will find all your recorded audio files.

USB-C Adaptor