ATTO Technology ExpressPCI UL5D 문제 해결 매뉴얼 - 페이지 9

{카테고리_이름} ATTO Technology ExpressPCI UL5D에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATTO Technology ExpressPCI UL5D 12 페이지. Single channel ultra320 scsi, pci-x host adapter dual channel ultra320 scsi, pci-x host adapter dual channel ultra320 scsi, pci express host adapter dual channel ultra320 scsi, low-profile pcie host adapter
ATTO Technology ExpressPCI UL5D에 대해서도 마찬가지입니다: 기술 사양 (2 페이지), 기술 사양 (2 페이지), 설치 및 운영 매뉴얼 (19 페이지)

페이지 인쇄

ATTO Technology ExpressPCI UL5D 문제 해결 매뉴얼

If the issue follows the attached SCSI devices, troubleshoot the attached

devices:

Verify the SCSI devices are powered on.

Check the SCSI devices to make sure that they are all set to different SCSI ID's.

Each device on each SCSI bus must use a unique ID, including the host adapter.

Devices on Bus 1 can have the same IDs as those on Bus 2. By default, the host

adapter uses SCSI ID 7, so devices should use ID's 0 through 6, or 8 through 15.

Check cable integrity. Check the cables for solid connections. Make sure they

are screwed down. Inspect cable ends for bent pins. U320 SCSI requires high

quality cables that are specifically rated for the U320 transmission speeds.

Verify the external terminator is the same SCSI type as the devices (certified as

usable for Ultra320 SCSI or lower) and does not have damaged pins.

Try attaching SCSI devices one at a time with different cables, adding drives and

cables until the problem occurs. This will help pinpoint the device or cable

causing the problem.

Watch the LED indicators on the SCSI devices before, during, and after startup.

Drive lights should also flash at startup as the SCSI bus is scanned. This may

give a clue as to the root cause of the issue.

The UL5D host adapter is detected by the operating system, it detects some of the

connected devices on both SCSI busses, but does not detect all of the connected

devices. The command dmesg can be used to see what devices are detected on each

SCSI bus.