DT Research DT313T 기본 작동 매뉴얼 - 페이지 3

{카테고리_이름} DT Research DT313T에 대한 기본 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT Research DT313T 4 페이지. Mobile tablet
DT Research DT313T에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (4 페이지)

페이지 인쇄

OPERATION

Internal Battery

Warning! !

The internal battery pack should only be replaced by an authorized DT Research service

representatve. Please contact your product and/or service provider for internal battery

replacement service.

Powering ON and OFF

To activate the DT313SC/ DT313T, push and quickly release the Power Button. The

display will come on in a few seconds. To put the DT313SC/ DT313T in Standby mode,

push and quickly release the Power Button. To turn the DT313SC/ DT313T oﬀ for

extended storage, power oﬀ safely using any software function that "shuts down

computer" provided in the software operating system.

NOTE:

The battery packs shipped with your tablet may be low in power—please use

the AC-DC adapter with the DT313SC/ DT313T when setting up for the first time

to fully charge the internal battery pack.

NOTE:

When the batterypack(s) is (are) charging, the blue-colored Battery LED should

blink slowly. If plugging in the AC-DC adapter does not trigger this blinking

activity and the LED stays dark, the battery pack(s) may have been drained

substantially. Try unplugging/ replugging the AC-DC adapter to the DT313SC/

DT313T a few times to activate the charging process.

NOTE:

To conserve power, use (push and quick release) the Power Button to put the

tablet in "Standby" mode while not in use. Pushing briefly on the same button

will wake up the system within seconds.

NOTE:

Avoid using the Power Button ("hold 4+ seconds" feature) to turn oﬀ the

tablet—this form of hardware shutdown is intended to be a means of recovery

from lockups, and not as normal operation.

Start Up

If the power up (from Standby mode or otherwise) is successful, the appropriate

interface will be displayed after a launch sequence of several seconds. The wireless

LAN connection may take 10-15 seconds to be established.

Conﬁguring the Mobile Tablet

The DT313SC/ DT313T may be configured using the utilities and methods dictated

by the software operating system. The DT313SC/ DT313T should be configurable

for various properties such as user profiles, network features, and several system

elements.

Wireless Networking

Wireless LAN

The DT313SC/ DT313T is often delivered with an embedded (user-inaccessible)

802.11ac WLAN adapter equipped with a hidden custom antenna.

•

Through the support of typical WLAN adapters, the DT313SC/ DT313T should be

able to detect all 802.11 access points in the vicinity for you to select the access

point of your choice for connection.

•

The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT313SC/ DT313T

and the access points have to match. The SSID is case-sensitive and it is recom-

mended that you enable WEP/WPA/WPA2 encryption (or advanced alternatives)

for secure access.

•

When WEP/WPA/WPA2 is enabled, you may need to consult your network

administrator or your networking equipment literature to properly configure

associated settings such as Authentication mode, etc.

•

Refer to the access point operating manuals for setting up the 802.11 access

points.