DT Research DT363Q 기본 작동 매뉴얼 - 페이지 2

{카테고리_이름} DT Research DT363Q에 대한 기본 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT Research DT363Q 4 페이지. Rugged handheld tablet

페이지 인쇄
DT Research DT363Q 기본 작동 매뉴얼
PRECAUTIONS
•
Always exercise care when operating and handling the DT363GL/ 363Q
•
Do not disassemble any portion of the DT363GL/ 363Q, as this will void any
product warranty.
•
Do not use any power adapter or charging cradle other than the one provided with
the tablet or acquired from the manufacturer or its partners.
•
In the unlikely event that abnormal noise, strange odor, or smoke is present,
immediately power down the DT363GL/ 363Q and disconnect all power sources.
Please report the problem to your device provider immediately.
The DT363GL/ 363Q
D
H
E
2
B
C
A
USB Type-C Port (power input)
A
SIM Card Reader (363Q)
B
SD Card Reader (363Q only)
C
Smart Card Reader (DT363GL only)
D
SIM Card Reader (DT363GL)
E
F
Speaker
Button Functions
BUTTON
ACTION
Power Button
1
Trigger Buttons
2
Battery Latch
3
2
1
I
J
K
Foldable
G
Antenna
Microphone
G
Barcode Scanner (optional)
H
Front Camera (optional)
I
Back Camera (optional)
J
NFC/UHF RFID Reader (optional)
K
OPERATION
Powering ON and OFF
To activate DT363GL/ 363Q, push and quickly release the Power Button. The display
will come on in a few seconds. To put the DT363GL/ 363Q in standby mode, push and
quickly release the Power Button. To turn the DT363GL/ 363Q off for extended storage,
power off safely using any software function that "shuts down computer" provided in
the software operating system.
NOTE:
The battery packs shipped with your tablet may be low in power - please use
the AC-DC adapter with the DT363GL/ 363Q when setting up for the first time to
F
3
fully charge the battery pack.
NOTE:
To conserve power, push and quick release the Power Button to put the tablet in
standby mode while not in use. Pushing briefly on the same button will wake up
the system.
NOTE:
When the battery pack is charging, the blue-colored Battery LED should blink
slowly. If plugging in the AC-DC adapter does not trigger this blinking activity
and the LED stays dark, the battery pack(s) may have been drained substantially.
Unplug/ replug the AC-DC adapter to the DT363GL/ 363Q a few times to
activate the charging process.
NOTE:
For DT363GL, avoid using the Power Button ("hold 4+ seconds" feature) to turn
off the tablet—this form of hardware shutdown is intended to be a means of
recovery from lockups, and not as normal operation.
3