DT Research DT395CR 기본 작동 매뉴얼 - 페이지 2

{카테고리_이름} DT Research DT395CR에 대한 기본 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT Research DT395CR 4 페이지. Mobile pos tablet
DT Research DT395CR에 대해서도 마찬가지입니다: 기본 작동 매뉴얼 (10 페이지), 기본 작동 매뉴얼 (4 페이지)

DT Research DT395CR 기본 작동 매뉴얼
The DT395CR
2
1
B
C
D
3
4
2
ENGLISH
A
Display mode LED
Battery status LED
F
E
Input/ Output Ports
Barcode Scanner (op�onal)
A
B
Headset Jack
USB Port
C
DC Power Input
D
Camera (op�onal)
E
LAN and 6-pin lockable connector for EIA/RS-232 (op�onal. Adapter cable required)
F
Bu�on Func�ons
BUTTON
ACTION
Programmable bu�on without the scanner module
1
As scanner trigger when equipped with the scanner module
Power on
Push/release typically enters Standby mode, or Push/release exits Standby mode or
2
restarts (so�ware dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
Brightness control bu�on, 5 levels
3
Up/ down bu�on
4
To adjust the speaker volume
Ba�ery and Power Management
The DT395CR is equipped with an internal Li-Ion ba�ery pack. The period between
ba�ery recharges can be significantly lengthened by pu�ng the tablet into Standby mode
through the Power Bu�on (see Bu�ons Func�on Table) whenever the tablet is not in
use. Depending on the opera�ng so�ware, the DT395CR may also be configured to enter
various power-saving modes via the Power Bu�on or through �med entry.
3
ENGLISH