ATTO Technology UL4D PCI 보충 설명서 - 페이지 6
{카테고리_이름} ATTO Technology UL4D PCI에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ATTO Technology UL4D PCI 8 페이지. Atto technology ul5d lp host adapters: supplementary guide
ATTO Technology UL4D PCI에 대해서도 마찬가지입니다: 호환성 차트 (1 페이지), 문제 해결 매뉴얼 (12 페이지)
페이지 인쇄
If the issue is not resolved, enable the Event logs as described below and
contact ATTO Technical Support.
Errors are reported while using the ATTO Configuration Tool.
Note: Sometimes when using the ATTO Configuration Tool, an error message
describing an unexpected event or incorrect information discovered by the
application will be displayed.
Use the help text presented with the error message to correct the issue.
The following conditions cause a warning or error message to be posted in the
"Status" area of the configuration utility. These messages will be shown in red.
An error occurred loading NVRAM data
highlighted, the application makes an attempt to read NVRAM from the card. If
the size of the NVRAM buffer does not match the expected size, or if the NVRAM
buffer couldn't be retrieved at all, this message is displayed.
Warning: NVRAM could not be read, defaults returned
a result of corrupt NVRAM. When the driver accesses the NVRAM, a continuity
check is performed on the NVRAM to ensure the returned data is valid. If this
check fails, the driver has no other alternative than to return a known NVRAM
data buffer that represents card defaults. When this situation occurs the defaults
are presented via the graphical user interface and the user is informed that the
values shown are defaults. These defaults must be committed in order to correct
the state of the NVRAM.
An error occurred updating the NVRAM
committal of NVRAM to the card. If the driver is unable to put the new settings on
the card, this message is displayed to the user and no changes are made to the
card.
This is not a flash file, or it is corrupt
proper file has been selected for flashing to the specific model of host adapter.
C.) Error Log Capabilities
The ATTO Ultra320 SCSI host adapter driver logs all failure related information to
an event log.
The driver records events broken into the following classifications.
FATAL
SCSI
ISP
LOOP
INFO
driver.
Page 6 of 8
Records various fatal situations within the driver and card.
Records SCSI errors as reported by the card.
Records errors as reported by the firmware of the card.
Records event notifications as reported by the firmware.
Records events related to the starting and restarting of the
ATTO Technology Inc. jokonczak
- The first time a host adapter channel is
- This message occurs as
- This message occurs during a
– Checks are performed to assure the
April 24, 2007