DT SWISS RATCHET EXP OS 기술 매뉴얼 - 페이지 11

{카테고리_이름} DT SWISS RATCHET EXP OS에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT SWISS RATCHET EXP OS 20 페이지.

2.9 CLEANING AND CHECKING ALL PARTS

1. Clean all parts of the hub, threaded ratchet, sleeve, spring and end caps. The existing grease

must be completely removed from the hub body and from the threaded ratchet.

2. Check the ratchets for wear.

The wear of the ratchets usually starts at

the outer circumference and shows itself by

strongly flattened edges with uneven wear.

In case of heavy wear, the ratchets must be

changed immediately.

3. Check the freewheel body for damages.

→ Grooves from the cassette are no damages. These are normal signs of usage.

1. Slightly grease the contact surface of the

bearing and the threaded ratchet.

2. Put the threaded ratchet with the toothing

facing downwards onto the mounting /

dismounting tool.

→ Put the ratchet on the side of the tool

with the fitting diameter. The ratchet

may only move minimally in the tool.

3. Put a new ball bearing with the colored side

facing downwards onto the ratchet.

4. Carefully press the bearing into the ratchet with light hammer strokes on the outer ring of the

ball bearing until the bearing protrudes 1 to 2 mm beyond the ratchet.

→ The ball bearing must not be pressed further into the ratchet.

Ratchet EXP OS - Technical Manual

HXTXXX00N6106S

1-2 mm