DTD RING 12 소유자 매뉴얼 - 페이지 13

{카테고리_이름} DTD RING 12에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTD RING 12 18 페이지. Buoyancy compensator

Threading the strap through the belt buckle

pic. 1

pic. 2

When finished, both parts of the Velcro should line up and ensure that the

buckle does not unfasten.

Assembly of the compensator for use with doubles

When using a buoyancy compensator with

doubles (two bottles connected by steel bands),

you first thread the wing on the screws, which

are incorporated in the middle of the steel bands

(just like when using one bottle, the inflator

elbow is on the side with bottles). Then proceed

by placing the backplate on the same screws.

Then fasten the whole system with wing nuts.

Correct attachment of the inflator hose:

pass the low-pressure inflator hose under rubber

bands on the corrugated hose. Continue by

passing it under the rubber band on the left strap

of the backplate above the D-ring, and attach

it to the inflator.

This way, the inflator will be in a place where

there will be no collisions with other equipment

and you will always find it where you need it.

Revised – February 2020

pic. 3

pic. 4