Attop X-PACK 17 사용자 설명서

{카테고리_이름} Attop X-PACK 17에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attop X-PACK 17 5 페이지.

페이지 인쇄

X-PACK 17 User Manual

(Suitable for wide indoor environments operation)

Suitable for 14 years old and above

Get 24/7 assistance at

Use camera or QR scanner to scan

Or Visit: https://attop.afterservice.vip

www.attoptoys.com

Customer Service Email : [email protected]

3. Package Contents

Drone X1

Remote X1

USB Cable X1 Propeller Guards X4

4. Charging

a. Low battery warning

When the drone is flying, the indicator lights on the drone are flashing, and the remote

control handle emits a "beep" alarm sound, indicating that the drone power is too low.

At this time, the drone needs to return and charge.

b. Charging Guide for battery

1. Connect the USB cable with power supply, the USB LED is solid Green, indicating

the USB cable is powering on.

2. Connect the battery with USB cable. When USB LED is solid Red, indicating

charging status. When USB LED is solid Green, indicating charging was completed.

Note： The connected USB Adapter should be less than or equal to 5V 2A, the voltage should

not be greater than 5V, otherwise there is a risk of overloading the USB cable.

The flight time is apporximately 9 minutes (Battery is in a full charging state.) and the charging

time is about 60 minutes.

Phone Clamp X1

Battery X3

Spare Propellers X2

Screwdriver X1

1. Aircraft Parameters

Length of main wing:

Total weight:

Charging time:

Flight time:

Gyroscope:

Working temperature:

Remote controller:

2. Remote Controller Parameters

Effective control reange:

Wifi transmission range :

(in a wide open area with no electromagnetic interference)

Working frequency:

5. Installing

(1) Open up all 4 blades for the drone.

This aircraft is a folding structure, please do open up all four blades before powering on.

(2) Install blades protector.

Expand the buckle of the propeller guard, and install it onto the drone wings.

(3) Install battery.

Insert the battery into specified

position.

Keep pressing the buckle of battery,

and then pull the battery back to take

it out.

80 mm

Aircraft:

100X125X40 mm

73g±2g

Battery:

3.7V500mAh

About 90 mins

8-9 mins

built-in

14°F to 104°F

2.4G

Motor:

7*20 4pcs

50 meters

30-40 meters

2.4G

Battery:

3xAAA

Remote Controller:

Keep pressing the buckle of battery

case, and then pull the case to take

it out, insert 3xAAA battery into

specified position.

AAA 1.5V

Battery Case