DTE Lux E 사용 설명서 - 페이지 6

{카테고리_이름} DTE Lux E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DTE Lux E 16 페이지. Curing light

5.2 Fix the light hood on the bottom of the optical fiber.

5.3 Uninstall the LED, just reverse the procedure above.

5.4 Battery replacement method: open the battery cover of the main

unit, take the battery out, than disconnect the plug slightly. Connect the

plug of the new battery correctly, put the new battery in, and then fix the

battery cover.

5.5 After using the machine or it is in need of charging, make the main

unit headon inserted in the pedestal and compress it to make sure the

main unit and pedestal chucking. When there is no need of charging,

please pull out the pedestal Adapter or put main unit into the pedestal

inversely.

6. Operation

6.1 Press the mode button to set the working mode, the corresponding

indicator will on when a mode set.

6.1.1 Full-power: the blue light radiates in full power.

6.1.2 Ramping: the blue light power increases stronger continually,

after 5 seconds reaches to the highest power.

6.1.3 Pulse: the blue light works on the pulse condition.

6.2 Press the time button to set the solidifying time, 4 working time is

available: 5, 10, 15, 20seconds.

6.3 When operating, aim the optical fiber at the correct position, press the

power button to start or stop to emit of the blue light.

6.4 During operation, the blue light can be stopped by press the power

button at any time.

6.5 A battery detect circuit is fixed inside the main unit, when low power

is detected, the indicator of the main unit will wink, please charge in

time.

6.6 Connect the Adapter and the charge device correctly, put the main