Attop YD-716 매뉴얼 - 페이지 7
{카테고리_이름} Attop YD-716에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Attop YD-716 7 페이지. 4-channel r/c helicopter with gyro
페이지 인쇄Esteemed Customers,
ve
ry
ihanks for your
choosing
our
YD-717
4
Axle Aircrafl from Attop,
please take your little time to refer to bellowed Quick Operation manual
if it
was your first
time to play
it,
and
it is
trusted to help you playing well.
This
4
Axle Aircraft
is
a standard aircraft model, nol
a
toy product. Please make sure
to
operate it under supervising by adult which having model-playing experience, supposing
juveniles
played
it.
Special notice point for new you:
1,
Please make sure to connect
ihe
power or charging
in
the righl way under the instruclion
of
positive and negative electrsde.
lf
opposiied way and inserted, or using unmatched
charger. the electric parts would
be
burnt out
instantly.
2.Turn
to
"*"
on low shift on controller when New you operated it,
if
losing control to bump
into something please trun the accelerator(power stick) to the lowest position
at
once,
to
make sure stopping to output power from the machine, which very important
for
protecting
lhe
aircralt to decrease the damage. Please keep it in mind strongly that, turn lowest the
power stick
if
ii seemed
to
bump into anything.
3. Frequency connection: charging enough the power on aircraft, then put
it on
horizontal posilion ( Green & red light flasing on receiving board to ready
for
Frequency connection; Turn on the power of controller to connect the frequency. The
controller would
get
the sound such as "Di
Di', and
red
light on receiving board
&
instruction light on controller flashing slowly, then push the power stick on controller from
lowest
to
uppest posiiion, and lowesl,
the
red light on receiving board turn green. and
red
one on controller turn
1o
be stable from flasing.
In
this way frequency connected, push
up
the
power stick on controller slowly to go for
it"
Remark: After connecting the
power,
the aircraft should be kept on horizontal
position,
or
it
would affect the degree 5f Gryoscope.
(
Supposed the instruciron light
on
bontroller
flashed slowly to show
it
not enough power after connecting frequency,
it's
necessary
to
use battery to make sure enough power.
lf
lailed to
connected frequency. Please repeat the
above way)
4,3D
unlirnited eversion: Turn to "+" on low shift on controller to get in Eversion
Mode.
When
hoveri*g
push the direction stick to the end of all direction quickly,
ihen
get into the
3D eversion performance.
Tips:push
a little
bit
throttle
stick
when
you
get
into the 3D eversion
pedormance.lt
can
,
,,tTl6ke
the aircraft more stable
and
smooth hovering after eversion.
but