dtec DYNertia3 빠른 시작 매뉴얼 - 페이지 19

{카테고리_이름} dtec DYNertia3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dtec DYNertia3 20 페이지.

DYNertia3 Quick Start (Inertia- Chassis type)

Troubleshooting

Most poor results are either due to electrical interference (via PC, accessories or DYNertia hardware) or from poor

selection of start and end points for the test.

OK- It has a good start point and decisive end

NOT

OK- Both these traces are running back under themselves at the test end. The trace should not run back under

itself or you effectively end up with 2 power readings for every RPM point and this is confusing to calculations we run.

Both the above files have a poorly set Max RPM (set in "Record Settings" field as below).

There is nothing wrong with the data, just needs a better setup of max and min RPM/speed

(start and end) at test time.

OK- It has a good start point and decisive end.

Note: Personally I would set the max RPM lower to prevent

the trace from dropping away and risking doubling back under.