Attwood FR-143RV(SS) 설치 지침 - 페이지 2

{카테고리_이름} Attwood FR-143RV(SS)에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Attwood FR-143RV(SS) 2 페이지. Deluxe shower sump system

페이지 인쇄

WIRING INSTRUCTIONS

WARNING:

Model 4137: Use 12-volt DC power source. Model 4138: Use 24-volt DC

power source. Higher DC voltage or AC voltage may cause serious damage

and/or personal injury.

Circuit must be properly fused to prevent possible fire hazard and/or damage

to pump and switch should the pump become jammed.

Caution:

All connections should be made using crimp-on connectors.

1. Electrical connections should be made as shown in Figure 4.

Figure 4

4-Amp. Model 4137

2-Amp. Model 4138

Two-Terminal, "On-Off" Type

Switch Can Be Attwood

•

Rocker, Push-Pull, or

Toggle Type

Sump System

•

2. Using butt connectors for 16-gauge wire, splice fuse holder into positive

lead (brown) in a location easily accessible for changing fuses. Install

the specified fuse.

3. Run brown wire from sump system directly to the positive (+) battery

terminal. If using manual on/off switch, run brown wire from sump system

to the switch, then to the positive (+) battery terminal.

4. Connect black wire from the sump pump system to the negative (-)

battery terminal to complete the circuit.

5. Re-connect power and water, and test unit for proper installation.

Feed water into the sump; if the flow appears to be too low, check

wire connections.

Note:

Reversed connections will result in opposite impeller rotation, which

drastically reduces capacity and can cause premature pump failure.

MAINTENANCE INSTRUCTIONS

Drain the unit during the winter months when not in use. Disconnect and

drain all lines to the unit. Remove hold-down clamps and empty the unit.

In some installations, it may be impossible to completely drain the system.

Add a non-toxic RV/marine antifreeze to the shower drain and circulate it

throughout the system.

For improved performance, periodically clean the filter. Remove the

cover and slip the filter out for easy cleaning. Re-install the filter and

cover when finished.

TROUBLE SHOOTING

Problem

Pump will not turn on

72" (183 cm)

Maximum Length

•

From (+) Terminal

to Fuse Holder

Brown Wire

•

–

Black Wire

DC Battery

12-Volt DC Model 4137

24-Volt DC Model 4138

Probable Cause

• Line is plugged

• Line is broken

• No power to the pump

• Fuse is blown

• System improperly wired

• Manual switch is not turned on

• Air is trapped in box—cover

needs to be vented

• Float Switch is jammed in

"off" position

Problem

Pump will not turn off

Pump output is low

System leaking at top

System is leaking at

inlet/outlet connection

Pump turns on but does not pump

Water returns to sump from

outlet hose

ATTWOOD LIMITED WARRANTY

ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331

("Attwood") warrants to the original consumer purchaser that Attwood brand

products will be free from defects in materials and workmanship under normal

use and service for one year from the date of original consumer purchases.

This limited warranty is not applicable if the product has been damaged by

accident, improper installation, unreasonable or improper use, lack of proper

maintenance, unauthorized repairs or modifications, normal wear and tear,

or other causes not arising out of defects in materials or workmanship.

Attwood products are warranted for use on pleasure boats. Any other

use — including but not limited to commercial, racing, or non-marine

use — are not covered under this warranty. Attwood's obligation under this

warranty is limited to repair of the product at Attwood's plant or replacement

of the products at Attwood's option without expense to the original consumer

purchaser. Any expenses involved in the removal, reinstallation or transportation

of the product are not covered by this warranty.

The product must be returned to Attwood's plant at the address above,

postage prepaid, and insured with proof of original purchase including date.

If Attwood is unable to replace the product and repair is not commercially

practical or cannot be timely made, or if the original consumer purchaser is

willing to accept a refund in lieu of repair or replacement, Attwood may refund

the purchase price, less an amount for depreciation. The acceptance by

Attwood of any product returned or any refund provided by Attwood shall not

be deemed an admission that the product is defective or in violation of any

warranty. Products that are replaced or for which a refund is issued become

the property of Attwood.

THIS WARRANTY IS ATTWOOD'S ONLY EXPRESS WARRANTY OF

THIS PRODUCT. NO IMPLIED WARRANTY SHALL EXTEND BEYOND

ONE (1) YEAR FROM THE DATE OF ORIGINAL CONSUMER PURCHASE.

ATTWOOD SHALL NOT BE LIABLE FOR ANY DAMAGES FOR LOSS OF

USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR

CONSEQUENTIAL DAMAGES, COSTS OR EXPENSES.

Some states do not allow limitations on how long an implied warranty lasts

or the exclusion or limitation of incidental or consequential damages, so the

above limitations and exclusions may not apply to you. This warranty gives

you specific legal rights, and you may have other rights which vary from

state to state.

Attwood

Subsidiary Steelcase Inc.

1016 N. Monroe Street, Lowell, MI 49331-0260

Probable Cause

• System improperly wired

• Float switch is jammed in

"on" position

• Box not mounted level

• Air is trapped in box—cover

needs to be vented

• System wired backwards

• Line is plugged/restricted

• Air is trapped in box—cover

needs to be vented

• Hose clamp is missing

• Hose clamp is loose

• Pipe connection is loose

• Line is plugged

• Outlet hose does not rise

continuously to thru-hull

• Check value plugged

or damaged