dtm MICRO2 868 설치 및 조립 매뉴얼 - 페이지 3

{카테고리_이름} dtm MICRO2 868에 대한 설치 및 조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dtm MICRO2 868 12 페이지. 2-channel radio receiver

1. RECEIVER INSTALLATION

The receiver consists of a splash-proof surface-mount housing with screw-rod antenna (Figure 1) and the electronic board

(Figure 2).

Receiver housing of IP-53 allows flexibility in selecting the mounting location. The receiver can be placed directly under the

gate driver cover as well as on the post of the fence.

Access to the screw terminals and interface of the receiver is possible after removing the external antenna and sliding the

receiver cover.

Before connecting the wires must be carried through the cable hole of 8mm diameter.

Receiver housing is equipped with theUSB connector cover, so you can access the connector without removing the cover.

USB

connector cover

Choosing a mounting location be aware of:

- the negative impact of electricity and metal objects neighborhood to receiver antenna,

- the negative impact of radio interference from sources other than the remote,

- the negative impact of dense development, humid or concrete walls,

- reducing the range of remote with used battery,

- increasing the range with increasing the height of the receiver antenna.

DTM System

spółka z ograniczoną odpowiedzialnością spółka komandytowa

handle with holes

Φ5mm

Fig. 1. Receiver housing.

screwd external antenna

sliding housing cover

cable entry

Φ8mm