ATV NBW429 빠른 매뉴얼 - 페이지 9
{카테고리_이름} ATV NBW429에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATV NBW429 13 페이지. Bullet network camera
페이지 인쇄
2.3 Resetting to the factory default settings
To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of User Manual) or use the Reset
button on the network camera inside the bottom cap.
•
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings using the
Reset button.
1)
Switch off the network camera by disconnecting the power adapter.
2)
Open the top cap.
3)
Press and hold the Reset button with a straightened paperclip while reconnecting the
power.
4)
Keep the Reset button pressed about 5 or more seconds.
5)
Release the Reset button.
6)
The network camera resets to factory defaults and restarts after completing the factory reset.
7)
Close the bottom cap tightly to ensure waterproof.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.30.220)
9