DTM System DTM-SWIFT 350 설치자를 위한 조립 지침 - 페이지 8

{카테고리_이름} DTM System DTM-SWIFT 350에 대한 설치자를 위한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DTM System DTM-SWIFT 350 16 페이지. Actuators for swing gates

2.4. Limiters

swing gate requires a limiter in the OPEN and CLOSE directions. Stops protect the drive, gate and

fittings against wear. Operating the gate without permanently fixed stops leads to its malfunction. It is often

dangerous, this leads to premature wear and will invalidate the warranty!

Fig 5. Configurations of the gate opening limiters - a mechanical limit stop

on opening present in the gate and delivered with actuators.

The actuators are equipped with an internal actuator stroke limitation system consisting of adjustable and

independent mechanical end stops (figs. 5 and 6), one for the opening stroke and one for the closing stroke

(optional). The use of internal stops is convenient when there are no limit switches or when there is no other way

to limit the gate leaf stroke. Wherever possible, it is recommended to use gate stop limiters.

Fig. 6. Use of an additional set of mechanical limit switches in the actuators.

open

closed