DTM System DTM GO800 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} DTM System DTM GO800에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DTM System DTM GO800 12 페이지.

SAFETY IN THE USE OF THE AUTOMATION SYSTEM

Non-observance and non-compliance with the notes in this manual may lead to an accident in

which people are injured or property damage occurs. Please read the following warnings carefully. The gate

drive ensures correct and safe operation only if the installation and use comply with the following safety

rules. DTM System is not responsible for accidents resulting from improper use or unprofessional

installation of devices.

During the operation of the automation system, both children and adults must keep a safe distance

from the operating automation.

The automation system can only be operated by properly trained adults.

Control devices should be kept out of the reach of children in order to protect the automation

system against accidental activation.

Movement between the gate leaves is allowed only when it is fully open.

Do not obstruct the gate movement.

Remove any obstacles that impede gate movement.

Signal lamps and signboards must be operational and clearly visible.

Manual operation of the door is possible only when the power supply is disconnected and the door is

unlocked.

In the event of a failure, disconnect the power, release the gate to allow access, and then call the

service center for necessary repairs.

Do not attempt to repair or maintain the system yourself. The system may only be serviced by

qualified personnel.

At least every 6 months, the operation of the automation system, protection devices and protective

circuits should be checked by qualified personnel.

Make sure that the persons who install, maintain or operate the gate automation follow these

instructions. Keep these instructions in a place where you can refer to them quickly when needed.

WARRANTY

DTM System delivers the equipment in working order and ready for use and provides a 24-month

warranty from the date of purchase by the end customer. The warranty period is determined on the basis of

warranty seals or the manufacturer's production batch markings placed on each product. DTM System

undertakes to repair the device free of charge if during the warranty period there are defects due to the

manufacturer's fault. The defective device must be delivered to the place of purchase at your own expense, with

a short, unambiguous description of the damage. The cost of disassembly and assembly of the device is borne by

the user. The warranty does not cover any damage resulting from improper use, unauthorized adjustments,

alterations and repairs as well as damage resulting from lightning, overvoltage or short circuit of the power

supply network. The detailed terms and conditions of granting a guarantee are regulated by relevant legal acts.