AddEnergie CoRe+PSV2 설치 매뉴얼 - 페이지 12

{카테고리_이름} AddEnergie CoRe+PSV2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AddEnergie CoRe+PSV2 14 페이지.

Preliminary Tests and Commissioning

Instructions:

• Apply power to the charging station, the following should be

observed immediately after power is turned on:

1: The status light is on continuously, its color will be green

2: The display shows the greeting message

• Scan the access card provided with the charging head , these

results should be observed:

1: Once the reader detects the card, it will emit an audible bip

2: Immediately after the bip, the access card will be

authenticated by the charging station.

3: If the authentication of the card is successful, the automated

test of the protection circuit will be performed.

4: Once the test is successfully completed, the overhead status

light will start flashing (white).

5: If the connector is inserted into an Electrical Vehicle, it will

begin charging, if not, after 1 minute, the station will be in wait

mode.

• Once the preliminary test is successfully passed, the charging

station can then be used as a private charging station (using the

provided access card(s)), or to be connected to AddÉnergie's

management system by turning on the communication Gateway

provided by AddÉnergie.