Comtech EF Data OAC-170D 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Comtech EF Data OAC-170D에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comtech EF Data OAC-170D 6 페이지. 70 mhz amplifier adjustment

GAIN EQUALIZATION

This procedure is performed to equalize the total gain through the receive path to the CS-

6716 modem. Gain Equalization is necessary for the modem to take advantage of the

multiple diversity schemes in the various AN/TRC-170 systems

STEP 1

For proper Gain Equalization, the system must not be in loop-back and the RX system

must be tuned at least 100 MHz away from the XMT frequency. If the antenna and

waveguide have not been installed, place the waveguide terminators or cover plates on

the receive ports of the waveguide entry panel. If the antenna and waveguide have been

installed, adjust the receiver amplifier converter and frequency synthesizer receive

frequency at least 200 MHz away from the normal receive frequency and at least 100

MHz from the transmit frequency. Make sure the HPA is off.

STEP 2

Set the CS6716 modem to Default Configuration and place Modem to Online state:

d. On the modem front panel keypad, select ENT for Main Menu then select

ON/OFFLINE, then select OFFLINE to place the modem in the offline state.

e. From the Main Menu select CONFIG, then select DEFAULT to set the modem to

default configuration.

f. From the Main Menu select ON/OFFLINE, and then select ONLINE to place the

modem into the online state.

STEP 3

On the modem front panel keypad, Select ENT for Menu, select MONITOR, then select

RSL to display the Receive Signal Level (RSL) for all four receive channels.

STEP 4

On each Downconverter, turn the Noise Test Switch to PRESEL as shown in fig 1.1.