Comtek M-169 운영자 매뉴얼 - 페이지 10
{카테고리_이름} Comtek M-169에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comtek M-169 14 페이지. Wireless microphone transmitter
페이지 인쇄M-169 FREQUENCY SELECTION
Frequency Selection (169.445 - 171.905 MHz)
The M-169 transmitter can operate on eight FCC dedicated assigned
channels for wireless microphone operation under FCC Regulation Part 90.
These channels may be used in two groups of four channels for
multi-channel operation. (Refer to frequency charts on page 9.)
After you have determined the channel on which
you are going to operate, position the two rotary
switches to indicate the channel and the mode of
operation. The left rotary switch determines
mode of operation. Position "1" is for
COMTEK companded receivers. Position
"0" is for non-companded receivers of
different manufactures other than COMTEK.
The right rotary switch selects the frequency by
channel number (1-8). (Refer to frequency chart on page 9.)
Multiple Channel Operation
When multiple transmitters are broadcasting in the same immediate area
(within 100 feet), the RF signals will "mix" together generating additional
signals. If these product frequencies are too close to a frequency which you are
using, you will experience intermodulation interference. This condition is
common to all radio receivers to some extent.
Simultaneous operation of more than three channels requires frequency
coordination to avoid intermodulation interference which could result in
poor or unusable performance.
To avoid this type of interference
, you should select frequencies from one
of the standard groups (see group frequency charts on page 9), or use COMTEK's
frequency selection software available at www.comtek.com to determine appropriate
frequencies or contact COMTEK to obtain a free copy.
Page 8