ATX SignalOn Series 설치 및 운영 매뉴얼 - 페이지 13

{카테고리_이름} ATX SignalOn Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATX SignalOn Series 16 페이지. L-band splitter module
ATX SignalOn Series에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지)

페이지 인쇄

INSTALLATION

Installation

Each splitter module occupies a single slot in the chassis. Use the following procedure to install modules in the SignalOn

Series chassis.

1. Make sure the ATX logo (or any other front panel lettering) is readable. Slide the plug-in module into its designated

location in the chassis.

Warning: Never install equipment in a wet location or during a lightning storm.

2. Secure the module using its two captive retaining screws.

3. After each module is loaded into the chassis, refer to your work order, and connect the designated RF cables to the

appropriate BNC or F connectors on the modules in the chassis.

4. Carefully route cables through the cable management slots located on each side of the rear of the chassis. Use the

cable management guidelines found in this manual to route cable from the chassis to the rack/cabinet.

5. Perform any cabling or operational tests required at your facility.

SignalOn

Series – L-Band Splitter Module – Installation & Operation Manual

CHAPTER 4: INSTALLATION

4-1