ABSTRACT VR8 매뉴얼 - 페이지 7

{카테고리_이름} ABSTRACT VR8에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABSTRACT VR8 15 페이지.

Timers
courtesy of
www.sxsevents.co.uk

Option list

These are the options on the VR, in order of appearance. The default setting is
shown.
display
default
option name
CHA
001
Set DMX channel
I-P
OFF
Pan invert
I-T
OFF
Tilt invert
P-T
OFF
Pan-tilt swap
CSN
OFF
Colour snap to half positions
GSN
ON
Gobo snap to full positions
CE
ON
CE compatibility mode
DBL
OFF
Display blanking mode
LSG
1
Light show group number
LSE
ON
Light show enable
SLO
OFF
Light show slow mode
STR
ON
Light show strobe enable
SOU
ON
Light show sound enable
ELS
OFF
Enhanced light show
RST
_
Soft-reset (reinitialise motors)
OPC
_
Option Clear (reset options to defaults)
TST
_
Self test mode
RUN
_
Run mode options
Page 20
Event production and Audio-Visual Services
Phone: 0870 080 2342
www.sxsevents.co.uk
Operating the VR
The VR uses up to six DMX channels as follows:
1: Mirror Pan (left-right movement)
2: Mirror Tilt (up-down movement)
3: Colour select
4: VR8 - Gobo / strobe select | VR8R - Gobo select
5: VR8R only - gobo rotation
6: VR8R only - shutter / strobe
If the VR8R is set to CE mode "ON" it willoperate in a condensed 4 channel
mode.
Pan/tilt
The mirror pan and tilt functions are proportional with automatic speed sensing
- if you move the control fast, the mirror will move fast; if you move the control
slowly, the VR will follow slowly and smoothly. The VR has options which allow
you to reverse the movement of the pan or tilt controls, and also to swap over
the pan and tilt channels.
Colour
The colour function is also proportional; this allows you to perform smooth
crossfades between adjacent colours. You need to send the exact values to
obtain full colours. Alternatively you can turn on option CSN which makes the
VR "snap" to the nearest half-colour. This can help you set colours if you are
using a controller with sliders. However, you cannot perform colour crossfades
in colour snap mode.
At the top end of the colour control, you can set the VR to scroll continuously
through the colours at variable speed.
Gobo
By default, the VR8 'snaps' to the nearest gobo. If you move the control slowly,
nothing will happen until the VR senses you are near the next gobo position,
when it will jump to the next gobo. Alternatively you can turn off the Gobo
Snap function if you want to scroll smoothly through the gobos, but you will
then have to send exact values to position the gobos properly.
The VR8-R always snaps to gobos.
Operating the VR
Page 5