AIRTRONICS 92524 운영 지침 - 페이지 2

{카테고리_이름} AIRTRONICS 92524에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRTRONICS 92524 2 페이지. 2.4ghz fhss-2 3-channel micro receiver

binding tHe receiver to your transmitter

It is necessary to pair the transmitter and receiver to prevent interference from radio controllers operated

by other users. This operation is referred to as 'binding'. Once the binding process is complete, the setting is

remembered even when the transmitter and receiver are turned OFF, therefore, this procedure usually only needs

to be done once for each separate receiver you're using.

1) Turn your transmitter ON.

2) Depress and HOLD the receiver's Bind Button.

3) Turn the receiver ON while continuing to hold the Bind Button. The receiver's Bind LED will flash slowly.

4) After 2 to 3 seconds, release the Bind Button.

5) Depress and HOLD your transmitter's Bind Button until the receiver's Bind LED begins to flash rapidly. The

binding process is successful when the receiver's Bind LED is solid.

6) Move the controls to confirm the transmitter and receiver are operating correctly.

The binding procedures differ from what is described if you're using the 92524 receiver with an M11X

transmitter. Refer to page 13 of your M11X Operating Guide for that transmitter's specific binding

procedure.

IMPORTANT If binding the receiver to an M11X transmitter, the M11X transmitter Modulation must first be

changed to FH2. Refer to page 47 of your M11X Operating Manual for more information.

setting tHe tHrottle Fail saFe

Your receiver features a Throttle Fail Safe function. The Throttle Fail Safe function automatically sets the throttle

to a predetermined position in the event that the signal between the transmitter and the receiver is interrupted,

whether due to signal degradation or to low battery. The Throttle Fail Safe function can be programmed after

the Binding process is complete.

1) Turn your transmitter ON, then turn your receiver ON.

2) Move the controls to confirm that the transmitter and receiver are operating correctly.

3) Move the throttle lever to your desired Throttle Fail Safe position and hold it in that position.

4) Press and HOLD the receiver's Bind Button for 4 seconds. The receiver's Bind LED will flash slowly.

5) Release the throttle lever AFTER the receiver's Bind LED begins to flash rapidly, then release the Bind Button.

6) Confirm the desired operation of the Throttle Fail Safe by turning the transmitter OFF. The throttle should

move to the position you set. Turn the transmitter back ON to resume normal control.

If the throttle lever is left in the Neutral position, the Throttle Fail Safe will be set in that position.

IMPORTANT FHSS-2 receivers support Throttle Fail Safe only. If you are using your receiver with an M11X

transmitter, you can only set the Fail Safe feature on the Throttle channel, unlike with FHSS-3 receivers.

warranty

Your Airtronics 92524 2.4GHz FHSS-2 3-Channel Micro receiver is warranted against manufacturer defects in

materials and workmanship, at the original date of purchase.

Any modifications or abuse of the product will void any warranty. Crash damage will not be covered by any

warranty. The receiver is not waterproof. Water damage will not be covered by any warranty.

Airtronics is Distributed Exclusively in North America by:

Global Hobby Distributors

18480 Bandilier Circle

Fountain Valley, CA 92708

http://www.airtronics.net

Telephone: (714) 963-0329

Fax: (714) 964-6236