ADDER ALIF1000 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} ADDER ALIF1000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER ALIF1000 4 페이지. Transmitter and receiver
ADDER ALIF1000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

Infinity browser-based configuration utility

To use the browser-based configuration utility, link a computer via

a network switch to the ALIF unit (Gigabit Ethernet is not essential

for the configuration stage). This configuration utility allows you to

perform all of the following functions:

• View/edit the IP network address and netmask,

• Configure separate IP network addresses for video, audio and USB,

• Configure multicast settings (on RX units),

• Configure video bandwidth settings (on TX units),

• View the current video output (on TX units),

• Perform a firmware upgrade,

• Perform a factory reset.

To access the browser-based configuration utility

1 Connect the Infinity unit and a computer via a network.

2 Run a web browser on your computer and enter the IP address of

the Infinity unit, e.g. http://169.254.1.33 or http://169.254.1.33

The default settings are as follows:

• TX units - IP address: 169.254.1.33 Netmask: 255.255.255.0

• RX units - IP address: 169.254.1.32 Netmask: 255.255.255.0

Note: Where the address of a unit is not known, perform a

manual factory reset (see left) to restore the default address.

TX (transmitter) unit configuration

In the ALIF system, the most important configuration details are

dictated by RX units. Thus, the TX unit setup is concerned only with

three main factors:

• Its IP address,

• The data streams to enable/disable, and

• Video signal optimization.

The method to set the IP address and data streams is exactly the

same as for the RX unit - please follow steps 1 to 3 of Configuring

the RX unit section on the rear page. In a Gigabit Ethernet network

with sufficient bandwidth, changes to the Video Configuration page

should not be necessary. If adjustments are required, please see the

AdderLink Infinity full user guide for details.

RX (receiver) unit configuration

Please see the rear page.