AIRTRONICS RD6000 SPORT 매뉴얼 - 페이지 4

{카테고리_이름} AIRTRONICS RD6000 SPORT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRTRONICS RD6000 SPORT 7 페이지.

Adjust endpoints so that the swash plate is not overcontrolled or "binds." Navigate to EL > EPA and

make adjustments as needed. Move the cyclic stick forward or backward to adjust the forward or

backward "elevator" endpoint. Use the

key to scroll to the "aileron" and "pitch" channels and

right-arrow

repeat the process.

Note: When using CCPM, endpoint adjustments effect the function, not one particular servo.

Throttle and Pitch Curves

The throttle / collective stick on your transmitter controls two functions at the same time. As the name

implies, it controls the amount of throttle applied, as well as the pitch of your main rotor blades. Five

point curves are available and allow you to custom tailor how your helicopter performs in each of the

four flight modes. (N, 1, 2 and 3.)

Traditionally, the Normal "N" flight mode is set up to perform somewhat like a fixedpitch helicopter,

with a low stick position you have zero throttle and zero degrees pitch, and with a high stick position

you have full throttle, and 912 degrees of pitch. Flight modes 1 and 2 are traditionally setup for

aerobatic flight, with varying amounts of throttle being applied at all positions, and your pitch varying

from negative to positive. Flight mode 3 is generally used for practicing auto rotations or to cut throttle

if you anticipate an imminent crash. Throttle is set to zero or idle for all stick positions, and pitch varies

from negative to positive.

Consult your helicopter manual regarding suggested starting values for throttle and pitch curves. If no

suggestions are listed, you can start with some basic throttle and pitch curves. See the diagram below.

Set the throttle curve for each of your four flight modes. Navigate to TH > CVPH, then P3, P2,

P1, PL. The lowest point is PL, and the highest point in PH. The flight mode you are modifying is

listed in the lowerleft section of your screen, under "FMode." Use the

button to scroll through

F-Mode

your four flight modes and set your various curves.

Repeat the same procedure for your pitch curves. Navigate to PF > CVPH, then P3, P2, P1,

PL. The lowest point is PL, and the highest point in PH.