daltile 1020 TS 운영 매뉴얼 - 페이지 13

{카테고리_이름} daltile 1020 TS에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. daltile 1020 TS 16 페이지. Tile

UNPACKING AND SETTING UP

Motor protection

The motor is equipped with a thermal safety

switch for protection against an overload. When

the motor gets overheated, the switch falls back

into its initial position and can only be switched

on again after the motor is cooled down.

Make sure to disconnect the machine from the

power supply before fitting or switching the cut-

ting blade or when doing any maintenance on

the machine.

Remove blade guard.

Block the sawing spindle with the 12 mm.

wrench.

Unscrew the 24 mm. hexagon nut with the

wrench and remove the saw flange.

Clean the saw flanges.

Fit the cutting blade on the center ring of

the spindle flange. (Check the direction of

rotation and make sure the blade is well

centered)

Mount saw flange and tighten with the

hexagon nut. Place blade guard and secu-

re it using the 2 knobs.

Adjustable cutting depth stop.

The adjustable stop is pre-set for a 10 inch

blade to prevent cutting into the Movable

Cutting Table.

When using smaller blades, the stop can

be adjusted to a cutting depth approxima-

tely 1/4 inch below the surface of the

Movable Cutting Table.

DALTILE 1020TS OPERATING MANUAL V02/2004R1 PAGE 13