Dametric TVD-M3 사용자 설명서 - 페이지 4

{카테고리_이름} Dametric TVD-M3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dametric TVD-M3 8 페이지. Touchpoint vibration monitor

Dametric

HANDLING

The 20 bar graph display indicates the Touch Point Vibration Signal or the alarm limit levels when

any of the push buttons is activated.

Limit 1.

 Push the switch to read the limit level on the bar display and adjust the corresponding

potentiometer to a chosen limit level.

 The yellow led diode is lit when the signal level is lower than the limit level.

Limit 2.

 Same function as limit 1.

 If both limits are used, this limit level is normally adjusted to a higher level than limit 1.

Production Attenuator.

 This potentiometer is used to change the attenuation during the production mode. Usually the

signal level will increase while the segment plates wears. The potentiometer is used to adjust

the touch point signal to a desirable level. Limit 1 can then be used as a warning level while

limit 2 can be used for interlocking.

 The potentiometer has no effect in the calibration mode.

Production Indication.

 This green led indicates that the production input is activated and that the unit works with

lower sensitivity.

Power supply.

 This green led is lit when the unit is powered.

TVD-M2-M3 EN.docx

Production

Limit 1

Limit 2

D/A Production

May 26, 2011 / BL

30 40

60 70

90 100

Touchpoint Level %

TVD-M2

Touchpoint Monitor

TVD-M2 / TVD-M3

4(8)