AIRTUG TT-HD-EA-15 조립 및 작동 지침 - 페이지 2

{카테고리_이름} AIRTUG TT-HD-EA-15에 대한 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRTUG TT-HD-EA-15 5 페이지. Trailer tugs

www.airtug.com

Loading:

Position the ball of tug under the receiver of the trailer and stop. Then either crank the

trailer down onto the tug (Manual) or push the button to raise the ball up into the ball receiver and lift

the tongue of the trailer up into the air (Automatic). Do not hold the button when the cylinder is

maxed out on stroke. This can cause damage to the cylinder motor and electronic circuits.

Plug in the trailer electric to the plug on the tug labeled "Surge Brake By-Pass" near the ball and this

will not allow the surge brake to lock up when pushing the trailer in reverse.

Battery Charging: Prior to the ﬁrst use, plug the charger cable into a 110V outlet or

extension cord and charge the batteries fully as indicated by the green light at the top

of the charger. The orange light indicates batteries are charging. Keep the battery

charger plugged in between use. See the battery charger manual for more information.

Handle Assembly

Slide the handle under the u-bolts that are on the frame.

Tighten the washers/nuts from underneath.