AIRTUG TT-M-EM-3 조립 및 작동 지침 - 페이지 2

{카테고리_이름} AIRTUG TT-M-EM-3에 대한 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AIRTUG TT-M-EM-3 4 페이지. Trailer tugs

www.airtug.com

Loading: Position the ball on the tug under the receiver of the trailer and stop. Then either crank the

trailer down onto the tug (Manual) or push the button to raise the ball up into the receiver and lift the

tongue of the trailer up into the air (Automatic). Do not hold the button when the cylinder is maxed

out on stroke. This can cause damage to the cylinder motor and electronic circuits.

Operating Instructions

Step 1: Prior to the ﬁrst use, plug the charger cable

into a 110V outlet or extension cord and charge the

batteries fully as indicated by the green light at the top

of the charger. The orange light indicates batteries are

charging. Keep the battery charger plugged in between

use. See the battery charger manual for more

information.

Step 2: If you purchased the "Surge Brake By-Pass",

plug in the trailer electric to the plug on the tug labeled

"Surge Brake By-Pass" and this will not allow the

brakes to lock up when pushing the trailer in reverse.

Step 3: Turn switch at end of handle to the "On" position. Select "FWD" or

"REV" and slowly press the thumb throttle to slowly begin movement of

the tug. Begin movement as slowly as possible.