dams Elev82 Mono Single Desk EVM-1200 조립 지침 매뉴얼 - 페이지 8
{카테고리_이름} dams Elev82 Mono Single Desk EVM-1200에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dams Elev82 Mono Single Desk EVM-1200 8 페이지.
페이지 인쇄
12
Step 12
It is now time to lift the desk over into its upright position. This is a 2 person lift, do not attempt
to do this without assistance as this could result in injury or damage to the product.
13
Step 13
Your desk is now ready to be connected to the mains outlet.
Before you proceed with operating your new desk it is recommended that you perform a full
reset of the controller to calibrate the height of each leg.
This can be done using the following steps;
Press button down for 3 seconds.
•
Continue pressing the button until both columns are in lowest position.
•
Keep pressing the button until control box makes 1 beep.
•
When control box makes 1 beep, it is confirmed that reset has been completed and button
•
can be released.
Now the desk is operational.
•
If the desk is disconnected by accidently pulling out the plugs at the control box, motors,
•
handset, main power source
or system status reach overload, overheat etc. then the desk must be reset.
•
If the desk is powered off intentionally at the main power switch, then the desk does not
•
need to be reset.
Operating the desk
Press the button, to operate the desk for upwards running.
Press the button, to operate the desk for downwards running.