DAN DRYER 3000 유지보수 및 서비스 매뉴얼 - 페이지 5
{카테고리_이름} DAN DRYER 3000에 대한 유지보수 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAN DRYER 3000 13 페이지. Hand dryer
페이지 인쇄Reference
Version
3000-ENG
08.01.2018
Regular maintenance:
To ensure a continued satisfactory function of the hand
dryer it is recommended regularly to remove dust etc.
from the machine.
The frequency of cleaning depends on the environment in
which the hand dryer is installed and how often it is used.
If the machine is used often cleaning is recommended at
least once a month.
•
Exhaust pipe and sensor must be cleaned with a
damp cloth.
•
Cleaning / vacuuming of the air intake holes in the
handdryer's cover.
If the machine is rarely used, we recommend cleaning
once every 6 months.
•
Exhaust pipe and sensor must be cleaned with a
damp cloth.
•
Cleaning / vacuuming of the air intake holes in the
hand dryer's cover.
In the event that the machine is used extensively and the
environment is very dusty, it may be necessary to clean
the inside of the machine regularly. See more in the
section "Cleaning the inside of the machine"
Trouble shooting:
Problem:
Hand dryer does not start:
Blows cold air only:
Poor air flow:
Other problems not covered by this
guide:
IMPORTANT:
If the unit is returned to DAN DRYER it must be accompanied by a detailed
description of the problem.
DAN DRYER A/S • Alsikevej 8 • DK-8920 Randers NV • www.dandryer.com • [email protected]
Document
3000 DAN DRYER Hand dryer.
Maintenance and service manual
Solution:
•
Check the 230V power supply.
•
Check IR sensor for dirt or damages.
•
Check that all electrical connections, wires etc. are intact.
•
If none of the above actions corrects the problem, it is either the IR sensor
or the relay that causes the problem and must be replaced.
•
Heating element unit has been overheated and must be replaced.
•
Timer is defective and must be replaced.
•
Dirt and dust in inlet and outlet impair the air flow. Clean the machine,
according to the section "Regular maintenance".
•
If the problem is not resolved by the above actions the entire hand dryer
unit must be sent for repair to DAN DRYER or replaced with a new one.
Lang.
UK
Important: To ensure
Cleaning / vacuuming
correct function the IR
of the air intake holes
sensor must always be
completely clean.
Page
5 of 12
.