Concens C4-MKII 사용자 설명서 - 페이지 2

{카테고리_이름} Concens C4-MKII에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Concens C4-MKII 9 페이지. Actuator controller for up to 4 actuators

U S E R M A N U A L

Preparation

Before the system may be used, the battery must be charged using the accompanying charger.

It takes 5-8 hours to fully charge a battery.

Battery mounted in charger

The yellow LED lights up when the charger is connected to power. Place the battery in the charger by sliding it in and

rotating it until it is pulled into place by the magnets. The green LED will flash at approx. 1 second intervals while the

battery is being charged. Once charging is complete the green LED remains permanently lit. Remove the battery by

rotating it 90 degrees. It will then be ejected and be ready for use.

Once the battery is fully charged, insert it into the controller. Follow the same procedure as for the charger. If

everything is OK, the controller will simply sound a beep (one second) once the battery is in place. If the system has

any faults, the beep will be followed by an error indication according to table 1 below.

When the battery requires recharging, transfer it to the charger as described above. It is recommended that you keep

an extra battery on hand to avoid disruption to operation.

Always wait at least two seconds after the last actuator has stopped moving before removing the battery. Otherwise

the controller may not have time to store the position and it may be necessary to perform 0-point calibration as

described in section 5.

C4-M K I I v6 62

U S E R M A N U A L

Battery, controller and handset

January 2022

Battery mounted in the

controller – ready for use