Dan's Comp Front Load Stem 설치 매뉴얼
{카테고리_이름} Dan's Comp Front Load Stem에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dan's Comp Front Load Stem 5 페이지.
페이지 인쇄Removing the Handlebars
•
Loosen and remove the clamping bolts holding the face plate
on the top of the stem.
•
Lay the handlebars on a workbench or on the floor away from
the bike so that they are not in the way.
These instructions are to be used as a guide only. Improperly installed parts may lead to severe injury or harm. We strongly recommend that
a properly trained bike mechanic handle all installations, adjustments and repairs on your bike. As always...Ride Safe!
AMain.com Inc.
Front Load Stem Installation
Tools Needed
•
Grease
•
Allen Wrench
•
Open/Closed end wrench
•
Adjustable wrench
Note: Tools needed will vary depending on the style of headset
compression cap and bolt being used.
Removing the old stem
•
Loosen the pinch bolts that are holding the stem tight, but do
not remove them.
1-844-970-4269
www.danscomp.com
Page 1