ADDER AdderLink X-Series 매뉴얼 - 페이지 10

{카테고리_이름} ADDER AdderLink X-Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER AdderLink X-Series 18 페이지. Usb extender
ADDER AdderLink X-Series에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지)

페이지 인쇄

Audio connections

Audio connections are available at the two 3.5" jack sockets mounted on the

side (same side as the switch bank) of the REMOTE module.

Note: When the REMOTE module is rack mounted, audio connections must

be made after the module has been fixed in place. Access is required to the

rear and above the rack. Remember to remove any audio connections before

attempting to slide out the REMOTE module.

1 Make the required audio connections according to the corresponding

connection(s) at the LOCAL module.

• Microphone connections are made to the REMOTE module socket

marked

• Speaker connections are made to the REMOTE module socket

marked

Note: The REMOTE module provides a signal boost feature to assist with

Microphone signal boost

unresponsive microphones. See

Link connection(s)

Links between the REMOTE and LOCAL modules are made via one (or two)

twisted pair cables, specified to Category 5 or higher. Ensure that the total

twisted pair cable length for each connection (including patch boxes) does not

exceed 100 metres.

• When extending only video and USB, only a single link cable is required.

• When extending video, USB and audio signals, two link cables are required.

Video and USB link cable

1 Insert the connector from the

primary twisted pair cable link

into the REMOTE module socket

marked 'USB + VIDEO'.

Audio link cable

Required only when using microphone

and/or speakers.

1 Insert the connector from the

secondary twisted pair cable

link into the REMOTE module

for details.

socket marked 'AUDIO'.