Concept Perugini PTR 200 지침서 - 페이지 14

{카테고리_이름} Concept Perugini PTR 200에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Concept Perugini PTR 200 16 페이지. Flail mowers

•

Slacken nuts indicated C

•

Slacken the 4 bolts indicated A which are situated under the gearbox

•

Slacken the counter nuts on B and either tighten or slacken bolt B

•

Once the desired tension has been made tighten all the nuts on B and

tighten nuts C

•

Move the gearbox either forwards or backwards in order to make the side

shaft square with the side of the ﬂ ail mower. This is very important as it

lengthens the life span of the belts and reduces uneven wear. Once this has

been achieved tighten bolts A

Stone Guards

The front stone guards are very important for

the protection of the tractor driver. Under no

circumstances should the machine be used without

the front stone guards. If the guards are bent, worn

or broken they should be immediately replaced,

failure to do so can result in severe injury and in

certain cases can cause death.

The picture shows the comparison between a used

worn and bent stone guard (top) and a new guard

(bottom).

If the machine is properly set up, set at the correct

height and the top tractor link is adjusted accordingly

then the stone guards should be able to hang freely

and not dig into the ground.

ALL MAINTENANCE MUST BE CARRIED OUT WITH THE TRACTOR

OFF,

P.T.O

SUPPORTED. FAILURE TO DO SO CAN RESULT IN SERIOUS INJURY

DISENGAGED

AND

THE

MACHINE

PROPERLY