AirTurn STOMP 6 사용 설명서 - 페이지 2

{카테고리_이름} AirTurn STOMP 6에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTurn STOMP 6 8 페이지.

STOMP 6 Instructions

Thank you for your purchase of an AirTurn STOMP 6 wireless controller. We

hope you enjoy the wonderful convenience of hands-free page turning, effects

management, lighting control, transcription control, media players, camera

control and other creative ways to trigger events with the STOMP 6. Send your

suggestions and comments to

DESCRIPTION

The STOMP 6 functions with select apps for Apple iOS™ iPhones, iPads, and

iPods, in addition to Bluetooth-equipped Android devices with apps that have

been designed to be compatible with the STOMP 6. Bluetooth equipped PC's and

MAC's may also use the STOMP 6 controllers in standard office apps and music

reading software.

The STOMP 6 consists of a power switch, six switches, an LED indicator, 9 volt

battery and a 9 volt jack for power.

Your STOMP 6 comes with a battery that is disconnected. To connect or replace

the battery, remove the 6 screws on the bottom of the case and plug in the battery.

If you intend to store the STOMP 6 for extended periods disconnect the battery.

The STOMP 6 was primarily intended to be an externally powered device using

a 9 volt DC adapter.

Disconnect the battery when using external power. Failure to do so will void

your warranty. The power supply must be a center negative supply.

To use the STOMP 6 with your MAC, PC, Android or iPad, make sure the host

computer you are using is in discovery mode. (Check the instructions that came

with your computer or Bluetooth USB dongle. For iPad users, go into "Settings",

then select "Bluetooth" and make sure it is turned on).

Turn on the STOMP 6 by pressing the power button for 1 second. The LED will

blink green then orange several times (if paired), and attempt to pair with your

computer. If your host computer requests a code, use 0000. If you are presented a

random code to validate the STOMP 6, accept it.