Abt KOSE507EWH 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} Abt KOSE507EWH에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abt KOSE507EWH 20 페이지. 27" (68.6 cm) and 30" (76.2 cm) electric single and double built-in oven flush installation kit
Abt KOSE507EWH에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (20 페이지)
페이지 인쇄Install Deflector Kit Bracket
This assembly is required for use when a single or double built-in
oven is installed in a flush installation.
1. Flex the upper vent piece (C) away from the lower vent piece
(D) to slide the deflector bracket (B) between them. Some
force may be required to flex the upper vent trim (C) away
from the lower vent trim (D). Some force may also be required
to flex the deflector bracket (B) and slide it into position.
Make sure screw holes are properly aligned between the two
pieces. See the following illustration.
2. Install the deflector bracket (B) to the lower vent piece (D)
using two #8-18 x ¹⁄₄" screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x ¹⁄₄" screw
is used on each side.
A
¹⁄₄
A. #8–18 x
" screws
C. Upper vent piece (supplied with oven)
B. Deflector bracket
C. Lower vent piece (supplied with oven)
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x ³⁄₈" screw (E) on each side of the vent tab
(B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
B
C
D
A
B
C
D. Deflector bracket
³⁄₈
E. #8–18 x
" screw
5. Replace the oven racks.
6. Replace the oven door. See the "Replace Oven Door(s)"
section.
7. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
8. Repeat for lower oven door.
9. Reconnect power.
10. The display panel will light briefly, and "PF" should appear in
the display.
11. If the display panel does not light, refer to the "Assistance or
Service" section of the Use and Care Guide provided with
your built-in oven or contact the dealer from whom you
purchased your oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
B
go back through the steps to see which step was skipped.
C
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
D
Check Operation of Single and Double Ovens
1. Turn on power.
2. At first use, set up the clock and any other preferences if
available. For more information, read the Use and Care
Guide.
3. Press BROIL on single oven models.
NOTE: Press UPPER BROIL or LOWER BROIL on double
oven models.
4. Set the temperature.
5. Press START.
If oven(s) does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See "Troubleshooting" section in the Use and Care Guide.
6. When oven has been on for 5 minutes, feel for heat.
If you do not feel heat or if an error message appears in the
display, turn off the oven and contact a qualified technician.
7. Press UPPER CANCEL/LOWER CANCEL on double ovens,
or press CANCEL on single ovens.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.
9