danalock Universal Module V3 매뉴얼 - 페이지 3

{카테고리_이름} danalock Universal Module V3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. danalock Universal Module V3 5 페이지.
danalock Universal Module V3에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지)

페이지 인쇄

Wiring

Set up your Universal module according to this schematic. Use

relay 1 before relay 2 if possible.

Ground

Power output: 12-24v DC 1amp

Relay 2: Normally open

Relay 2: Common

Relay 2: Normally closed

Relay 1: Normally open

Relay 1: Common

Relay 1: Normally closed

Power input: 12-24v DC 1amp

Ground

Click commands

You can configure the Universal Module via the button found in

the small hole on the module. When you get to the setting you

want, wait for 5 seconds and the Universal Module will react. If you

make a wrong number of clicks, just stop at an unmarked number

of clicks and wait for 5 seconds. The LED will flash red.

Clicks

Color

Green

This command is for setting up the Universal Module with a smart home gateway

such as Z-Wave or ZigBee (not HomeKit). The Universal Module will respond by

blinking green. Now the module is in ex/inclusion mode and you have 30 seconds to

pair or unpair it with a gateway.

Red

Deletes all settings and all keys on the Universal Module. The Universal Module will

respond by blinking red.

Activity

Inclusion mode

Reset the Danalock