Ducati Scrambler 밸브 측정 및 조정 사용자 매뉴얼 - 페이지 8

{카테고리_이름} Ducati Scrambler에 대한 밸브 측정 및 조정 사용자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ducati Scrambler 11 페이지.

Measure

NOTE: The Opening Shim has a Flat side and a recessed side. Using light pressure,

close the dial caliper all the way and "zero" the unit: hold the On/Off/Set button

until all Zeros appear in the display.

Open the Caliper sufficiently to allow the Opening

Shim to fit between the jaws of the micrometer.

The flat side of the Opening Shim should rest

against the stationary jaw of the micrometer. The

moveable portion of the micrometer will fit inside

the recessed portion of the opening shim

Record the measurements in Appendix 1.

If the closing shim needs replacement, remove the opening shim as described in the

previous section. The valve stem is exposed with the opening rocker slid to the side.

Remove the Opening shim (6) from the valve stem.

Place a clamp on the valve. In addition to having the

cylinder at TDC, this is a little extra insurance to keep the

valve from dropping into the cylinder.

Press down on the Closing rocker to expose the retaining

rings. Slight engine rotation may be required to get the

rocker to move far enough to expose the retaining rings. The

retaining rings are in two halves.

http://www.ducatitoolrental.com/