Elite Acoustics Engineering A2-5 매뉴얼 - 페이지 9
{카테고리_이름} Elite Acoustics Engineering A2-5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Elite Acoustics Engineering A2-5 11 페이지. Acoustic amplifier with 4 channels, mixer, effects, battery powered and bluetooth
Elite Acoustics Engineering A2-5에 대해서도 마찬가지입니다: 빠른 매뉴얼 핸드북 (5 페이지)
페이지 인쇄
1.
To fully charge a unit –
a. Set Battery Switch to "CONNECT"
b. Turn Power Switch OFF
c. Connect "AC" adaptor to Power Jack.
d. Blue "Charge" LED should be lit, Charge time can vary from 5 to 6 hours
e. Once it is fully charged LED "Blue Color" will turn off.
2.
When unit is powered with "AC" adaptor, Battery Switch should be in "DISCONNECT"
position if Battery is already fully charged.
3.
Battery Switch should be on "DISCONNECT" when unit is packed for transit or unit
is in storage. Make sure battery is fully charged before UNIT is put into storage. We
recommend fully drain and then fully charging the battery at least once each month.
•
Battery Type: LifePO4 - Lithium Iron Phosphate.
•
Charge Battery when is LOW or Depleted.
•
Use & recharge battery at least once a month
•
DO NOT leave power switch in the "ON" position when it is not
in use. Doing so after a long period of time will damage the
battery
•
If unit is always plugged in, it is recommendate to put Battery
Swtich in Disconnected position, but make sure to recharge unit
monthly.
•
Keep unit in a cool, dry place away from extreme temperatures
•
Do not service, modify, or replace the battery
•
If the battery fails to charge, contact Elite Acoustics Engineering
A25U - BATTERY & RECHARGING INFORMATION
•
New Porudction - A25U Battery Meter -
•
•
3 - Charged. This LED will turn on when battery is fully
charge and will turn off once the unit is powered ON
after a full charge. This LED is not part of the battery
level meter.
•
2 - normal
•
1 - normal
•
LOW - less then 10%
•
CHARGE - charging LED will turn off when battery is
fully charged.
FOR MAXIMUM BATTERY LIFE