Elite Cedar 2436BS 조립 지침

{카테고리_이름} Elite Cedar 2436BS에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Elite Cedar 2436BS 2 페이지. Planters

Assembly Instructions

Stain your cedar planters for protection from the sun's UV rays. If you want to

retain the natural cedar look, there are some clear or "neutral" stains on the

market designed strictly for protection without colorization. Just make sure the

stain you select contains UV inhibitors. UV damage is one of the leading causes of

cedar wood discoloration, leading to a gray, washed-out look.

Tools Required

: Changeable bit Screwdriver or electric Drill (Bit included in this Kit).

Growing Medium: 4.3 CuFt (not included)

Parts

(4) Legs

(8) Slats

(1 has pre-drilled holes)

(2) Long Panels (Slat Supports)

(2) Short Panels (NO Slat supports)

(4) Corner Caps

(1) Bottom Shelf

(1) Wood Block

Hardware

(1) Special Screw driver Bit

(9) Small (1 ¼") screws

(4) Medium (2") screws

(4) Large (2 1/2") screws

(1) Liner (gray fabric)

Elite Cedar

Elevated Planter #2436BS

for

NOTE 1:

All holes are pre-drilled and screws are included.

*DO NOT overdrive screws

**Be Careful not to discard any parts with packaging.

NOTE 2:

Cedar has a "finished side and edge" that should always face outward

and upward. Identify the non-finished side (circled item in image

below highlights non-finished area).

Notice the top "finished edge" is placed

upward and the non-finished side

inward so it is covered by the growing

medium.

Planters

Slat Support

(Inside)