2Box Drumit Three 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} 2Box Drumit Three에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2Box Drumit Three 20 페이지.

2Box Drumit Three 빠른 시작 매뉴얼
OUT 1~4
These are the DrumIt Three's outputs, which can be connected to a
mixer or amplifier. By default, OUT1 and 2 transmit the mixed
stereo signal. OUT3 and 4, on the other hand, are assigned to
BUS3 and BUS4 respectively. If necessary, OUT 1 and 2 can also
output BUS signals (BUS1 and BUS2). This can be set on the
UNIT-OUT page.
PHONES
This is where you can connect a commercially available pair of
headphones (recommended impedance 32 Ω - 600 Ω).
LINE IN
This is where you can connect an external signal source. You can
use a stereo cable (for your smartphone, for instance) or a mono
cable (e.g. to listen to the monitor signal via the DrumIt Three in a
live setting).

7 USB

When the DrumIt Three module is connected to a USB port on your computer (PC
or Mac) and booted in USB mode, the computer will consider it a "regular" storage
device. In this case, the module behaves exactly like a USB hard disk or an SD
card (in a card slot). You can drag and drop sound files from your computer to your
2BOX module and exchange files between the module and the computer. Managing
2BOX sounds is thus as straight-forward and fast as exchanging digital photos,
MP3 files and Office files. To boot the DrumIt Three module in USB mode, press
and hold the leftmost DATA button above the display while switching the module
on.
The display now looks as follows:
No USB connection
If the module is connected to and recognized by the computer, the letter "R" (below
"Stat") refers to read mode, while "W" refers to write mode. Please bear in mind that
Active USB connection
12 / 20