ADDER AdderLink X-Series 매뉴얼 - 페이지 5

{카테고리_이름} ADDER AdderLink X-Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADDER AdderLink X-Series 15 페이지. Usb extender
ADDER AdderLink X-Series에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

페이지 인쇄

Stage B - Mounting the module – desk or rack

The Dual Video Transmitter can be situated on a desk (or floor) or alternatively,

for larger installations, mounted within an optional rack mount chassis.

Desk mount

Apply the supplied self-adhesive rubber feet to the

underside of the module.

Rack mount

Note: The module switches are not accessible

once it is inserted into the rack, therefore, check all

settings before insertion.

1 Place the rack securing plate (available as a separate kit) onto

the front of the module and secure it with the two countersunk screws.

2 Orient the Dual Video Transmitter module on its side so that its labelled face

is the correct way up and the two blue video connectors are facing into the

rack.

3 Slide the module into the required rack position. The rectangular cut-out in

the front upper lip of the rack allows the two screws on the module's upper

edge to slide through.

4 The rack mount chassis has a series of holes in its floor that are

spaced to accommodate the two screws on the module's lower edge.

Ensure that the screws correctly locate into the

two holes of the chosen slot. The rack

securing plate on the module should now

be flush with the front of the rack

mount chassis.

5 Use the third (pan-head) screw, in the top hole of the rack securing plate to

fasten the module to the rack.

Rack

securing

plate

Pan-head

screw

Countersunk screws x 2

Stage C – Connections

Most connections to the Dual Video Transmitter are common to both of the

operational modes, while other connections differ depending on whether the

'Two-in, two-out' or 'One-in, two-out' modes are selected.

Installation Advice

For correct operation, the local and remote units must have ground connections.

At the computer end, this is achieved by ensuring that the computer or

KVM switch that the AdderLink is connected to has a ground connection.

At the keyboard / monitor / mouse end, this can be achieved by ensuring

that the AdderLink's power supply is connected to a grounded power outlet.

Alternatively, a ground connection will be made via the monitor, if the monitor is

itself grounded.

Try to avoid laying the interconnect cable alongside power cables where

possible.

Connections at the Dual Video Transmitter

Power connection

The Dual Video Transmitter can obtain its power perfectly well from its keyboard

connection to the computer system. Thus, if the keyboard connection is made

to the computer, the power adapter is not necessary. If, however, the Dual Video

Transmitter will not use a keyboard connection, then the power supply must be

used:

1 Attach the output connector of the power supply

to the socket at the front edge of the module

labelled POWER.

2 Insert the IEC connector of the supplied

power lead into the corresponding socket

of the power supply. Connect the other

end of the power lead to a nearby mains

socket.

When power is applied, either via the

keyboard connector or power supply,

the small indicator situated on the

front edge of the module adjacent the

POWER socket will glow red.

Note: It is also possible to supply power to the module using the Expansion

connector situated adjacent to the configuration switches. The use of this

connector is beyond the scope of this user guide.

Note: The module contains an internal automatic cut-out fuse to protect against

power surges. To reset, remove power from the module for one second and

then reconnect.